How to flash the firmware

You should choose the firmware based on the version of your motherboard and the installed drivers. The images at the top of the page can help you identify them.

Make sure to use a micro-SD of good quality and with a maximum capacity of 32 GB, formatted in FAT32. Empty its contents, and then transfer the contents of the folder to the micro-SD card..

To ensure the accuracy of the content located at the root of your SD card (USB on some 3.1 motherboards), make sure it matches one of the example images shown below.

EVO MEGAKIT 230

Afterward, insert the card into the printer. When the device starts up, the firmware will be loaded (this process may take a few minutes). Once the printer restarts, the installation will be considered complete.