FlSun SuperRacer

0 %

Contenu du cours

Assembly and Calibration

We invite you to watch the assembly and setup video in its entirety, even if it's not your first 3D printer.

The printer has many cables and connectors. Most of them are inside the chassis and not visible. However, some of them are loose, especially those going to the print head and on the gantry. Be careful to route them correctly during assembly to avoid snagging when the moving parts of the printer are in motion.

The printer comes with all the tools necessary for assembly and setup. There are additional tools that are not required for assembly but may be needed if certain parts need to be disassembled. Remember to keep them.
At the end of assembly, you may have some extra screws or additional components left. These are spare parts in case of loss or other issues. Please keep them safely.
As mentioned in the video, the nozzle may have remnants of filament, and the Teflon (PTFE) tube may have small marks at each end. This is perfectly normal, as many components of the machine are factory tested, especially the print head and the extruders.